Tech-source Raptor 4000 (for Solaris) User Manual download pdf (Page 12)

Raptor 4000/4000e Drivers (Solaris)

3.2 Requirements

The following are prerequisites for installing the Raptor

4000/4000e drivers for Solaris:

• The system is running Solaris 9 or higher.

• At least 2MB of disk space is available in /usr and /.

• One or more of the cards listed in Section 4.1 are presently

installed in the system.

3.3 Installing Raptor 4000/4000e Card

Driver Software

The following are step-by-step instructions for installing the “Raptor

4000/4000e Drivers (Solaris)” software from a CD-ROM.

1. Install a Raptor card in the computer as described in

Chapter 2.

2. Boot the computer with the -r (reconfiguration) option by

performing the following steps:

• Power ON the computer.

• Wait until you see boot messages displaying on

the screen, then press and hold the Stop (L1)

key, and then press the A key.

• At the ok prompt, type boot –r.

3. After the system comes up, log in as root.

4. Insert the CD-ROM labeled “Raptor 4000/4000e Drivers

(Solaris)” into the drive.

5. If /cdrom/cdrom0 exists, the CD-ROM was

automatically mounted. Change directories to the CD-

ROM by typing the following:

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 40 41

No comments

Tech-source Raptor 4000 (for Solaris) User Manual Page 12