Tech-source Raptor 4000 (for Solaris) User Manual download pdf (Page 9)

Chapter 2

HARDWARE INSTALLATION

2.1 Hardware Configurations Supported

The Raptor cards have been tested on and currently support the

following Sun Microsystems workstations:

• Ultra 25

• Ultra 45

2.2 Installation Instructions

Installing a Raptor card is simple and consists of a few easy steps.

Step 1: Shut down the system and turn the power OFF. Remove

the system’s cover along with any cables that prevent you

from doing so. Find an available PCI or PCI Express slot,

and remove the bracket and screw. Ground yourself by

touching the metal part of the case.

Step 2: Install the Raptor card firmly into the PCI or PCI Express

slot. Take care to press it evenly and snugly into the slot.

Once you are certain the card is installed properly in the

slot, secure it with the bracket screw.

Step 3: Secure the system cover and reattach any previously

removed cables, and connect the video cable to the

monitor.

NOTE: If your Sun hardware (workstation) is not listed here, please

contact Tech Source for compatibility verification.

NOTE: Remember which cables go to which connectors. You

may want to label the cables and connectors before

disconnecting them.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 40 41

No comments

Tech-source Raptor 4000 (for Solaris) User Manual Page 9